NEW - Error Codes

Error Codes:
1 regular flash indicates Over voltage protection
2 regular flashes indicate Under voltage protection
3 regular flashes indicate Over current (Motor phase is short-circuited or phase to ground is short-circuited)
4 regular flashes indicate Stall Protection (motor stalled for too long)
5 regular flashes indicate Hall sensor input is abnormal (or connector disconnected)
6 regular flashes indicate MOSFET protection (MOSFET self-checking is abnormal)
7 regular flashes indicate Phase wire disconnected (or faulty windings)
8 regular flashes
9 regular flashes
10 regular flashes indicate Self-checking error protection (System internal power-on self-checking is abnormal)
11 regular flashes indicate Controller overheating
12 regular flashes indicate Abnormal throttle signal
13 regular flashes indicate Motor over-heat protection (Motor temperature is higher than safe value)
14 regular flashes indicate Throttle or control harness are disconnected or faulty

Undocumented:
Error 15 indicates that the brakes are applied (or brake switch/wiring fault).
Error 16 may simply be an indication that the controller is still in programming mode or possibly that the USB Cable is still attached.